Purchase & study exam preparing with NSE7_FSN_AR-7.6 pass-king quiz training materials

Fortinet NSE7_FSN_AR-7.6 Exam Overview:

Fortinet NSE7_FSN_AR-7.6 Exam Syllabus Topics:

Fortinet NSE 7 - Secure Networking 7.6 Architect Sample Questions:

1. What are two reasons you might see iprope_in_check() check failed, drop when using the debug flow?
(Choose two.)

A) Packet was dropped because of policy route misconfiguration.
B) Trusted host list misconfiguration.
C) VIP or IP pool misconfiguration.
D) Packet was dropped because of traffic shaping.

2. As an IT manager, you want to delegate the installation and management of your SD-WAN deployment to a managed security service provider (MSSP).
Each site must maintain direct internet access and be secure. You expect significant traffic flow between the sites and want to delegate as much of the network administration and management as possible to the MSSP.
Which two MSSP deployment blueprints address your requirements? (Choose two.)

A) Install the hub and spokes on the customer premises, and enable the MSSP to manage the SD-WAN deployment using FortiManager with a dedicated ADOM.
B) Use a shared hub on the MSSP premises with a dedicated VDOM for the customer, and install the spokes on the customer premises.
C) Install a dedicated hub on the MSSP premises for the customer, and install the spokes on the customer premises.
D) Use a shared hub on the MSSP premises and a dedicated hub on the customer premises, and install the spokes on the customer premises.

3. Refer to the exhibit, which a network topology and a partial routing table.

FortiGate has already been configured with a firewall policy that allows all ICMP traffic to flow from port1 to port3.
Which changes must the administrator perform to ensure the server at 10.4.0.1/24 receives the echo reply from the laptop at 10.1.0.1/24?

A) Enable asymmetric routing under config system settings.
B) Modify the default gateway on the laptop from 10.1.0.2 to 10.2.0.2.
C) A firewall policy that allows all ICMP traffic from port3 to port1.
D) Change the configuration from strict RPF check mode to feasible RPF check mode.

4. What are two functions of automation stitches? (Choose two.)

A) You can configure automation stitches to execute actions sequentially by taking parameters from previous actions as input for the current action.
B) You can set an automation stitch configured to execute actions in parallel to insert a specific delay between actions.
C) You can configure automation stitches on any FortiGate device in a Security Fabric environment.
D) You can create automation stitches to run diagnostic commands and attach the results to an email message when CPU or memory usage exceeds specified thresholds.

5. Which of the following regarding protocol states is true? (Choose one answer)

A) proto_state=10 indicates an established TCP session.
B) proto_state=01 indicates an established TCP session.
C) proto_state=00 indicates that UDP traffic flows in both directions.
D) proto_state=01 indicates one-way ICMP traffic.

Solutions: